程序使用8085微处理器中的查找表查找数字的平方
我们编写了一个8085汇编语言程序，该程序使用查找表在地址字段中显示数字及其平方来查找一位数的平方（0到9）。
FILE NAME MYSQR.ASM ORG C100H X: DB 00H, 01H, 04H, 09H, 16H, 25H, 36H, 49H, 64H, 81H ORG C000H CURAD: EQU FFF7H UPDAD: EQU 06BCH IBUFF: EQU FFFFH MVI A, 0EH ; Load A with 0000 1110B SIM ; Unmask RST5.5 i.e. enable keyboard interrupt. ; The next 4 instructions check if a key is pressed. If a key is ; pressed, RST5.5 pin gets activated but does not interrupt the 8085 ; as it is in DI state. But RIM instruction execution reveals that ; RST5.5 is pending. In such a case, the loop is exited. AGAIN: DI RIM ANI 00010000B JZ AGAIN ; Stay in this loop till a key is pressed EI NOP ; RST5.5 interrupts the 8085 now. Only after NOP is ; executed, interrupt system is enabled. ; So control is transferred to RST5.5 ISS. Details of this ISS ; is discussed in a later chapter when Intel 8279 chip is discussed. ; Execution of this ISS results in location IBUFF getting loaded ; with code of key pressed. Then the control is passed on to the ; program segment shown below. LDA IBUFF CPI 0AH JNC AGAIN ; If code is >= 0AH, jump to AGAIN. LXI H, X ; Point HL to the beginning of the look up table. MOV L, A ; Load L from A. Thus, point HL to the location which ; contains the square of the number input by the user. MOV A, M ; Load A with the square of the number. MOV H, L ; Load H with the number whose square is desired. MOV L, A ; Load L with the square of the number. SHLD CURAD CALL UPDAD ; Display the number and its square. JMP AGAIN ; Jump to read the next value from the keyboard.